About
About SandCalc: How These Estimates Work
What SandCalc calculates, where the material densities come from, and how to use the order slip numbers when you talk to a supplier.
Why this site exists
SandCalc is a small set of free calculators for bulk materials: sand, topsoil, crushed stone and paver base. Each one takes your measurements and returns cubic yards, cubic feet, tons, bags and an estimated cost on a single order slip you can read to a supplier over the phone.
The four steps every calculator uses
- Square feet comes from your length and width, or from a diameter or a triangle base and height.
- Cubic feet is square feet multiplied by depth in feet.
- Cubic yards is cubic feet divided by 27.
- Tons is cubic feet multiplied by the material density, divided by 2,000.
Your waste allowance is applied to the volume before those conversions, so every figure on the slip includes it.
Densities we use
- Sand: 100 pounds per cubic foot.
- Screened topsoil: 90 pounds per cubic foot.
- Crushed stone: 105 pounds per cubic foot.
- Paver base: 110 pounds per cubic foot.
These are planning values for dry material. Damp material is heavier, and the density a supplier uses is the largest single reason two quotes for the same job differ.
What the prices mean
Each calculator starts with a placeholder price so the cost line is not empty. That number is not a quote for your area. Overwrite it with the price your supplier gives you, and switch between per cubic yard, per ton and per bag to match how they quote.
Estimates, not quotes
Every figure here is an estimate. Prices vary by region and season, delivery is not included, and site conditions change how much material a job actually consumes. Confirm density and price with your supplier before you order.
Where to go next
Start with the sand calculator if you are filling a sandbox, top-dressing a lawn or bedding pipes. Use the topsoil calculator for beds and raised beds, the stone calculator for driveways and drainage, and the paver base calculator before you lay a patio.